CNC 车铣加工中心

Okuma Mac Turn 550 W

The machine has been maintained annually under a service contract with Okuma.

Okuma Mac Turn 550 W
Year of manufacture: 2005
Control: OSP-E 100 L
Max. turning diameter: 720 mm
Distance between tailstock tip and spindle nose: 2,505 mm
Y axis travel: 250 mm
Main spindle speed: up to 3,500 rpm
Spindle motor power: 30 kW
Lower turret with 12 stations
Milling spindle with infinitely variable B axis
80-position tool magazine
HSK 100 tool holder
3-jaw chuck, diameter: 315 mm

In 2023, the cable carrier for the W axis including all hoses was replaced.
In October 2024, the linear guides for X/Y/Z axes were renewed.
All work was carried out by Okuma.
The machine was cleaned.
Covers and sheet metal parts were dismantled.
8th axis dismantled.
Travelling column dismantled and removed from the machine. ATC dismantled and removed from the machine.
All linear guides removed.
Mating surfaces of the ZA axis cleaned.
New ZA axis linear guide incl. carriages installed and secured at specified torque.
New ZA axis ballscrew incl. bearings installed.
Gbedpfeyt Nvtex Aagji
Base plate for the travelling column installed and secured at specified torque, respectively fastened to carriages. Lubrication lines connected.
ATC including auxiliary components reinstalled and connected.
New YA and XA linear guides installed and tightened to specification. New YA axis ballscrew with bearings installed.
Travelling column installed and lubrication lines connected. XA base plate installed and aligned.
8th axis installed and aligned.
H1 turret mounted
- Install drive motor for 8th axis
- Assemble 8th axis and new H1, set geometry
- Function test for 8th axis and H1
- Run-in program for B axis approx. 12 hours, then drain old oil from 8th axis
- Run-in program for H1 and create defect report for OEG
- Install left door, adjust various covers
- Install chuck
- Adjust zero points
- Check tool change

该广告为自动翻译，可能存在翻译错误。