工业挂车 VAL30 – 25吨载重

Multi-Trans VAL30

Operating conditions:
The industrial trailer is designed for use on level, paved surfaces in internal transport operations.

Multiple trailer operation:
The trailer components are not designed (without a coupling device) for combined operation with multiple trailers.

Payload:
The industrial trailer can carry loads up to a maximum of 25 t at 6 km/h with evenly distributed loading (surface load) between the axles. Point or line loads are only permissible upon notification.

Base frame:
The base frame of the industrial trailer consists of a robust welded construction made of profile steel.

Loading platform:
Dimensions are approx. 6000 x 2400 mm. Loading height approx. 750 mm. The platform is covered with softwood planks and bordered with all-round edge protection.

Steering:
Four-wheel axle pivot steering, drawbar can be raised, detached, and swapped from front to rear. Drawbar eye height at towing vehicle approx. 285 – 775 mm (other heights only possible upon notification), drawbar eye according to DIN 74054, diameter 40 mm, drawbar drop safety device according to UVV.

Chassis:
Both axles of the industrial trailer are steered. Solid elastic rubber tires approx. 559 x 356 mm, wheel hubs with tapered roller bearings and long-life grease lubrication.

Paintwork:
Finish in RAL 5002 ultramarine blue.

Additional equipment:
Nkedpfx Aexrtb Nsf Sju
Two lashing rods made of round steel are welded vertically into the outer side frames on each longitudinal side of the industrial trailer.

Rental or sale EU-wide.

廣告是自動翻譯的，翻譯中可能會出現一些錯誤。