金属板折弯机 - 4 辊

MG MH 2010 B

sheet width 2050 mm
plate thickness 10.0 mm ST
pre-bending 8.0 mm ST
diameter of upper rolls ~ 220 mm
side roll diameter ~ 170 mm
diameter of lower rolls ~ 190 mm
bending speed ca. 2.0 + 5.0 m/min
Control ELAP LYNX
oil volume 80.0 Liter
voltage 380 V
total power requirement 5.5 kW
weight 5000 kg
range L-W-H 3500 x 1550 x 1400 mm
Current new price incl. accessories: approx. € 90.000
Special price on request

Equipment:
- Robust electro-hydraulic 4-roll plate bending machine
- 4-roll design offers a wide range of bending and rolling capabilities
- MG NC control unit "ELAP LYNX"
* Operation – control of all rolls and machine axes
* Digital position display
* Manual operation via joysticks
* Movable control panel
- Two central rolls driven directly by hydraulic motors
- Conical rolling possible via roll tilting
- Side roll parallelism maintained via torsion shafts
- Pre-bending on both ends
- Diameters up to 1.1 times the top roll diameter are possible
- Forged and hardened rolls (hardness: 53–55 HRC)
- Low-maintenance, robust machine design
- Permanent lubrication for all bearings
- Sturdy welded steel construction
- Selectable bending speeds (2 settings)
- Electro-hydraulic drop-end bearing for easy removal of rolled parts
- Pressure gauge/display for rolls
- Safety system (safety trip wire with switch unit)
Tedpfx Aijz N Hxho Tod
- Operating manual (PDF)