压铸机

Frech DAK 315

Clamping force: 3150kN, opening force: 10,000daN, closing stroke: 500mm, ejector force/retraction force: 159/82kN, ejector stroke: 120mm, mould height: 300-700mm, platen dimensions: 900x900mm, tie bar spacing: 550x550mm, tie bar diameter: 110mm, injection position: mm, max. injection force: 350kN, injection stroke: 430mm, injection plunger diameter: 50/60/70/80mm, shot volume: 563/811/1103/1441cm³, specific injection pressure: 1783/1238/909/696daN/cm², corresponding projected area: 177/254/347/453cm², max. projected area: 1050cm² at 300daN/cm², operating pressure: 140bar, dry cycle time (DIN 24480): 500, drive motor: 22kW, control: Datacontrol, length: 6900mm, width: 2000mm, height: 2800mm, weight: 14t, operating hours: 77,185h, shot count: at least 1,147,108, however not guaranteed due to a hardware replacement, adjustable opening stroke, with Striko Westofen W455 holding furnace, ABB IRB 2400 (M96/F10) industrial robot, and documentation. An on-site inspection is possible.
Dsdpfxsza E Rme Acrekn