可换车身（平板和篷布）

Fliegl Wechselbrücke 7,82m Jumbo

Customized Transport Solution
Configure your Fliegl vehicle to meet your specific requirements. The vehicle shown is an example. Production and equipment are customized according to customer specifications.

Tandem Trailer Chassis
Welded steel construction with a floor assembly approximately 152 mm high; load-bearing and torsionally rigid steel frame construction. Longitudinal beam floor construction with a load-resistant outer frame and guide tunnels spaced 600 mm apart; tunnels feature guides on top and sides, tunnel height approx. 45 mm; 4 x swap body corner fittings based on a 20-foot standard.
4 side-extending/folding parking feet with dual locking mechanism for a parking height of 970 mm, with support leg rest
Side door stops
Rear impact protection made of flat bar
Pallet stops on both sides, approx. 20 mm high with perforated profile for securing straps; loading height is reduced by approx. 20 mm
Floor
Screen-printed panels approx. 27 mm thick, for high point load capacity, for forklift axle load up to max. 4,400 kg
Front wall/corner stanchions
Approx. 2,580 mm high, remainder covered with tarp; steel corner stanchions in full-size design; release mechanism for side tarp on front wall
Inner front wall additionally lined with a 1,250 mm high screen-printed panel
Center stanchions
1 pair of sliding stanchions adjustable along the entire length, with 4-compartment pockets and a long pocket at the bottom.
1 pair of stanchion positions

Slotting Slats
5 rows of wooden V-shaped slotting slats
Rear wall/rear corner stanchions
Rear steel corner stanchions extending to the bottom edge of the roof, tarpaulin attachment with round tube and tarpaulin tensioning ratchet
Rear portal doors, double-leaf, each with 2 internal twist-lock latches
Tarpaulin
Tarpaulin, with welded-in horizontal and vertical straps, reinforcements for stanchions
Stainless steel tensioning fasteners
Roof
Sliding roof, rear end lift folds up, roof can be slid from rear to front, L-shaped roof rail for the automotive industry, interior width between roof rails approx. 2,490 mm, tarpaulin color: white
EcoLift – lifting roof by approx. 380 mm, liftable on both sides, with gas spring assistance,
Registration / Plates
Country of registration: Germany
Fliegl manufacturer’s certificate for body strength in accordance with EN 12642 XL,
Fliegl manufacturer’s certificate for body strength in accordance with DL 9.5, pallet stops on both sides, approx. 20 mm high, loading height reduced by approx. 20 mm
Fliegl manufacturer’s certificate for load securing in accordance with VDI 2700, Sheet 12 ff. Pallet stops on both sides, approx. 20 mm high; loading height is reduced by approx. 20 mm
Paint Finish
Frame Hot-dip galvanized, including passivation
Front corner posts Hot-dip galvanized
Front wall Aluminum
Lhedpskt Ni Uefx Af Tjh
Rear corner posts Hot-dip galvanized
Rear wall White