垃圾车

Fliegl DHKA 390 50 m³

Further information
Chassis tipper semi-trailer
Fine-grained steel welded construction, lightweight design, fifth wheel plate with interchangeable 2 kingpins
Curved front end Patented
24 t. 2-speed support winch, single-side operation, with straight lower section, without thrust compensation
2 wheel chocks with holder
Underride guard, folding
Half-shell mudguards
Integrated mudguard holder Stone-repellent surface
With anti-spray flaps on last axle only
1 tarpaulin pole with bracket
2 towing hooks at the rear
Axles+suspension
SAF disc brake axles with 430 mm disc diameter
Axle/chassis laser-measured Reduction in tire wear and fuel consumption
Axles in off-road version,
Air suspension
1st axle automatic lift axle, including forced lowering and starting aid, actuation of 3x brakes (starting aid is functional up to an axle load excess of 30% and up to a speed of max. 25 km/h)
Hot-dip galvanized lift axle mechanism 10-year warranty against rusting through
Brake system
2-line compressed air brake systemColor-coded cable routing for easy servicing.
Spring-loaded parking brake
2 interchangeable front clutch heads, without connecting line
EBS, electronic braking system with EBS socket at the front, without connecting cable
Attention: The trailer may only be towed by towing vehicles that guarantee the effectiveness of the ABS!
with lifting & lowering valve
Vehicle stability system
Wheels and tires
385/65 R22.5 tires of the manufacturer's choice
Steel rims, factory silver
Electrical system
24 volt, multi-chamber lights, amber LED lighting at the sides
2 white position lights at the front
2 white/red rear lane departure lights
2 x 7-pin interchangeable sockets at the front, without connecting cable
Hydraulics
Low-pressure cylinder max. 170 bar, smallest stage hard-chlorinated, with HDK screw socket, fixed part, NW 48 mm (without hose connection).
Hydraulic actuation via truck power take-off
Troughs
Aluminum box body made of high-quality, abrasion-resistant 5 mm thick front wall, with external walls made of 30 mm hollow chamber profiles, cleanly welded, with bulk material-repellent top rail profile. Inside with access to front wall (not in conjunction with Cramaro).
Shovel and brush holder on the outside of the front wall.
Greenline - conical and aerodynamic trough shape
Membrane rear wall
Rear wall pendulum-mounted with double-joint hinge and with 2-leaf door partition 1/2 to 1/2, with pivoting gallows at the top, with one grain slider per door.
Rear panel with rubber sealNote! Heat-resistant up to max. 170°C!
Floor 6 mm thick throughout
Standing platform with access, connection plate for air/electric and brake with large clearance for best possible operability.
Roller tarpaulin on one side for depositing in FR-right, with central locking in FR-left
Operating instructions
For salt, lime, etc. We recommend a tipping cylinder with a hard chrome-plated piston rod so that it is not attacked by the material and rusts.
The specified total weight is technically possible; depending on the load, the total weight may not be reached if the permissible axle/support and fifth-wheel loads are observed. (Poor driving and trailing behavior possible due to incorrect load distribution)
Godji Ri Ihspfx Af Aeuh
Country of registration / plates
Germany
Test approval according to EC 2007/46
24/7 service hotline
Prepared for single-line license plate holder
Contour marking with reflective strips according to ECE R 048, white on the sides and red on the rear
Paint finish
Frame DB 7350 Novagr

廣告是自動翻譯的，翻譯中可能會出現一些錯誤。