数控车铣中心

DOOSAN Puma 2600SYII

CNC Turning and Milling Center Doosan Puma 2600 SYII with Fanuc i Series Control including Accessories

The machine has had very little use, with approximately 1,730 spindle hours, so it is as good as new and available from 01.01.2026.

Additional accessories for Doosan Puma 2600 SY II lathe:
- 2 tool holders for external turning tools 25x25
- 1 double tool holder for external turning tools 25x25
Lodpoxauwbjfx Adxjai
- 1 tool holder for face machining 25x25
- 2 tool holders for internal turning tools (boring bars) diameter 50 mm
- 1 double tool holder for internal turning tools diameter 32 mm
- 1 tool holder for parting-off tools
- 1 double right tool holder for external tools (sub spindle)
- 1 double left tool holder for external tools (main spindle)
- 4 driven tool holders ER-32 radial (X axis)
- 5 driven tool holders ER-32 axial (Z axis)
- 1 driven tool holder ER-32 radial (X axis) with internal coolant supply
- 1 driven tool holder ER-32 axial (Z axis) with internal coolant supply
- 1 three-jaw chuck for main spindle with 1 set of hardened jaws + 2 sets of soft jaws
- 1 three-jaw chuck for sub spindle with 1 set of hardened jaws + 2 sets of soft jaws
- 1 collet chuck for main spindle including collets for Ø50 mm and Ø30 mm
- 1 collet chuck for sub spindle including collets for Ø50 mm and Ø30 mm
- 1 set of reduction sleeves for Ø50 mm (10 pieces)
- 1 set of reduction sleeves for Ø32 mm (7 pieces)
- 1 set of adapters for driven tool holders (ER 32 collet, Weldon, milling holder)
- Flushing device with coolant on main spindle for automatic jaw cleaning
- Device for automatic jaw cleaning with compressed air
- Additional high-pressure pump for internal coolant supply (drilling with indexable drills)
- Automatic machine shut-off function (machine also switches off the main power, thus disconnecting the power supply)
- Interface for automatic bar feeder magazine Iemca

廣告是自動翻譯的，翻譯中可能會出現一些錯誤。