加工中心

BIESSE ROVER A SMART 1632 5 axis

We are selling a 5-axis machining center, Biesse Rover A 1632 Smart, manufactured in 2017. The machining center is in very good condition due to relatively infrequent use since its purchase. We are the first owner.

Isdpfx Acoz R I U Iebetn
I have attached the file "Cartellino_1000020374" to the listing below. This is a manufacturer's document describing the configuration of the offered machine according to Biesse standards.

Technical specifications of the machining center:
‣ Working areas *:
X = 3280 mm;
Y = 1580 to 1660 mm, depending on operating conditions.
Z = 200 mm (configuration with 5-axis unit, drilling head, and H=74 mm modules).
Z ​​= 240 mm (configuration with 5-axis unit, drilling head, and H=29 mm modules).
‣ Configuration 2
‣ 6 ATS tables – 18 carriages
‣ Rear row stops with 115 mm travel and 25 mm extension.
‣ Intermediate row stop located at coordinate 1190 mm with 140 mm travel.
‣ 4 side stops with 140 mm travel (2 right + 2 left) with pneumatic system.
‣ Sensor to verify stop retraction.
‣ 4 support bars for H=74 mm modules.
‣ Claw-type vacuum pump with 250 m³/h capacity.
‣ Vacuum module – Size 132x146 – H74 mm with high-friction surface and pre-installed vacuum seal.
‣ Vacuum module – Size 132x75 – H74 mm with high-friction surface, pre-installed vacuum seal, and pre-installation for locating pins. ‣ Vacuum module – Size 132x54 – H74 mm with high-friction surface, installed vacuum seal, and pre-installation for locating pins.
‣ Automatic lubrication system.
‣ Sawdust and chip removal conveyor.
‣ 5-axis interpolating machining unit, 13 kW (17.4 HP), HSK F63 tool holder, liquid-cooled.
‣ Coolant supply unit.
‣ Additional Z-carriage for machining units, controlled by an independent Z-axis.
‣ BH 17 L drilling head.
‣ 16-position rotary tool magazine on the X-carriage.
‣ 12-position linear tool magazine mounted on the machine frame.
‣ HSK F63 adapter with integrated flange for saw blades used in 5-axis units.
‣ 300 mm diameter saw blade for integrated-flange mounting.
‣ bSolid software.


If the information above is insufficient, please contact me and let me know what you would like to know.
Upon request, I can provide a document in English with a detailed description of our machining center's layout.


Best regards, Ihor Balychev.